New function
Translate an application requirement into an initial technical scope to be reviewed.
Do you already have a mould or a new idea?Choose where to start →Pathway 02
Before the mould comes one question: is rotational moulding the right process?
An initial feasibility assessment clarifies the function, requirements, quantities and path to production at an early stage, avoiding investment based on unverified assumptions.
Simulate a feasibility enquiryWhen to start the discussion
The idea may still be open. The objective must be clear.
This pathway is suitable for those exploring a solution, developing a design, revising a product or preparing for initial industrialisation.
Revision
Reconsider an existing solution when its use, requirements or production arrangement changes.
Industrialisation
Prepare the steps that connect the idea, mould, samples and potential series production.
From the initial question to series production
A pathway that clarifies each decision.
No phase automatically leads to the next: each step depends on the outcome of the preceding review.
Function and context
We start with the problem the product must solve and the environment in which it will be used.
Requirements
Clarifying the requirements, quantities and project horizon enables a meaningful initial assessment.
Process fit
We assess whether rotational moulding is appropriate for the application and our normal operating scope.
Manufacturability
If the fit is positive, the geometry and decisions required to progress towards the mould are examined in greater detail.
Sample or pilot run
Trials are set up using criteria to be agreed before any series production begins.
Industrialisation
Production and its conditions are defined only when the project is sufficiently mature.
Initial information
What is needed for an initial feasibility assessment.
- Product function and problem to be solved
- Current phase: idea, design, prototype or revision
- Environment and main conditions of use
- Indicative annual quantities
- Known essential requirements
- Desired timing for a potential start-up
No CAD files in the initial enquiry.
You may indicate that drawings or prototypes are available, but the files may be requested only after an initial discussion with our team.
Next step